Warping Mill - Table model Leclerc

VERTICAL WARPING MILL - Leclerc Table Model
Using a mill is the fastest way of making warps with a mix of  threads and colors. They are used for making varying warp lengths according to number of turns in winding. The cross sections that hold the pegs may be adjusted up or down, depending on the warp length. When the mill is not in use, the cross sections and pegs can be removed so that the mill folds to occupy a very limited space.

Table model gives 2 yards (1,8 meters) per turn and can warp up to 22 yards long and work well if also using a warping paddle to wind up to 20 threads at the same time

Full factory lacquer finish, the red yarn is NOT included.

Height:38" (96 cm)
Width: 26¼" (67 cm)

6340-2000